Dowel PGA-110 without thermal head

Dowel for thermal insulation, review
Dowels for fastening insulating materials with a nail are designed for fastening thermal insulating materials. Particularly good for materials with mineral filler in concrete, natural stone, brick, aerated concrete.

Plastic nail material: nylon
Metal nail material: carbon steel

The dowel for fastening insulating materials with a nail has a two-section wedging zone and a wide plastic pressure washer with a diameter of 60 mm.
Thanks to the notches and spikes on the rod, the tear and shear characteristics are improved
Reverse dowel teeth allow fasteners to be firmly secured in solid materials
Special holes in the rod reduce the fragility of the product and increase the degree of wedging during installation
The presence of stiffening ribs at the point where the cap is attached to the plastic rod ensures rigidity of the fastener
The wide cap ensures a tight and reliable fastening due to greater coverage of the area of insulating materials
All of the listed characteristics of the dowel design ensure easy installation and reliable fastening of the thermal insulation material to the load-bearing base. The dowel is fixed in the wall by driving a metal nail

Types of dowels for thermal insulation and their areas of application:

- hot-dip galvanizing of the metal nail increases corrosion protection
- metal nail is designed for fastening all types of heat-insulating materials up to 100 mm thick
- a metal nail with a thermal head is intended for fastening thermal insulation in “wet” facade systems
- a metal nail with a thermal head eliminates corrosion of the connection and the formation of “cold bridges”